Smart House Project
The photos you see below are the photos captured during the Smart House Project. The first of the three slideshows are the pictures of the house itself. And the second are pictures of the arduino board and how it was incorporated wit the house.
|
|
The Photos you see to the left are the photos captured of the house that we used for our project. The first two photos are birds eye views of the house, we used tile for the floor so that the house had a sturdy foundation and could handle a little bit of pressure. Pictures three to five show the front and back doors of the house, we used cardboard for the walls of the house so because they were easy to use and manipulate for our purposes and they could still function. Pictures six to nine show different angles of our house, as you can tell, my group used quite a bit of glue for the walls so that they were even more sturdy, in total we used 47 glue sticks. The final two photos of this slide show the center of our house, we have the cardboard piece in the middle because could not find a tile the could fit in that space without ruining part of our house.
|
|
These photos shown on the left are the photos captured of the Arduino part of our smart house. The first five pictures show the Arduino board controlling the "furnace", it controls a light that would turn on if the sensor detected the temperature to be too low. Photos 6-10 are the photos of our ultrasonic positions at our front door, this censor would, if armed, detect if anything entered through the door which would set off an alarm. The last three photos show the lighting we have placed throughout the house which we could turn on either with a button switch, or remote control.
|